TM-9-2320-365-20-5 LMTV Unit Maintenance Manual M1078 Series - Volume 5 Download
Page 115 of 666
TM 9-2320-365-20-5 Change 2 20-256.5 c. Cleaning/Inspection. d. Assembly. (1) Apply sealing compound around the edge of all exterior exposed surfaces. (2) Install two lockwashers (1), coupling (2), seals (3), and nuts (4) on pump box (5). WARNING WARNING • Dry cleaning solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and gloves; use only in well ventilated area; avoid contact with skin, eyes, and clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when using solvent; the flashpoint for Type I dry cleaning solvent is 100 degree F (38 degree C) and for Type II is 130 degree F (50 degree C). Failure to comply may result in serious injury or death to personnel.’ • If personnel become dizzy while suing dry cleaning solvent, immediately get fresh air and medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts eyes, immediately flush eyes with water and get immediate medical attention. Failure to comply may result in injury to personnel. NOTE Clean all metal parts with dry cleaning solvent and dry using compressed air prior to inspection and assembly. Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel.