TM-9-2320-365-20-4 LMTV Unit Maintenance Manual M1078 Series - Volume 4 Download
Page 87 of 968
TM 9-2320-365-20-4 d. Door Latch/Lock Assembly. NOTE Both latch/lock assemblies are installed the same way. Right side shown. (1) Attach two control rods (1 and 2) between handle/lock assembly (3) and release assembly (4). (2) Insert release assembly (4) and two control rods (1 and 2) upward through handle/lock assembly (3) opening in door (5). (3) Seat handle/lock assembly (3) into door opening by pushing handle/lock assembly toward front of vehicle until rear of handle/lock assembly can enter opening, then push handle/lock assembly toward rear until handle/lock assembly is fully seated. WARNING Adhesives, solvents, and sealing com- pounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing. Keep away from open fire and use in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel. (4) Apply sealing compound to threads of setscrew (6). (5) Position handle/lock assembly (3) on door (5) with setscrew (6). (6) Tighten setscrew (6) to 70-85 lb-in. (8-10 N·m). (7) Position washer (7) and nut (8) on setscrew (6). (8) Tighten nut (8) to 70-85 lb-in. (8-10 N·m). Change 1 16-49