TM-9-2320-365-20-4 LMTV Unit Maintenance Manual M1078 Series - Volume 4 Download
Page 69 of 968
TM 9-2320-365-20-4 Change 2 16-35 NOTE (3) Position door (7) on cab with hinge (1) in slot in forward edge of door and bolt holes aligned with openings in door. (4) Position door (7) on hinge (1) with three washers (8) and screws (9). (5) Position door (7) on hinge (4) with three washers (10) and screws (11). (6) Position door (7) so that gap between door and cab is approximately equal all around. (7) Tighten three screws (9 and 11) one-half turn. (8) Open, close, and open door (7) to ensure correct operation. (9) Tighten three screws (9 and 11) to 22-26 lb-ft (30-35 N•m). (10) Apply grease to hinges (1 and 4). (11) Install four clip nuts (12) on door (7). (12) Install wiring harness (13) through access hole in forward edge of door (7). (13) Install door arrestor assembly (14) on cab with washer (15), two spring washers (16), and screw (17). (14) Install door arrestor assembly (14) on bottom of door (7) with two screws (18). Step (5) through (7) requires the aid of an assistant.