TM-9-2320-365-20-4 LMTV Unit Maintenance Manual M1078 Series - Volume 4 Download
Page 62 of 968
TM 9-2320-365-20-4 16-5. DOOR REPAIR/ADJUSTMENT (ALL MODELS EXCEPT M1081) (CONT) d. Door Latch/Lock Assembly. NOTE Left and right door latch/lock assemblies are assembled the same way. Right door latch/lock assembly shown. (1) Attach control rods (1 and 2), between handle/lock assembly (3), and release assembly (4). (2) Install release assembly (4) and two control rods (1 and 2), upward through handle/lock assembly opening in door (5). (3) Seat handle/lock assembly (3) into door opening by pushing handle/lock assembly toward front of vehicle until rear of handle/lock assembly can enter opening, then push handle/lock assembly toward rear until handle/lock assembly is fully seated. WARNING Adhesives, solvents, and sealing com- pounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing. Keep away from open fire and use in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel. (4) Apply sealing compound to threads of setscrew (6). (5) Position handle/lock assembly (3) on door (5) with setscrew (6). (6) Tighten setscrew (6) to 39-59 lb-in. (4-7 N·m). (7) Position washer (7) and nut (8) on setscrew (6). (8) Tighten nut (8) to 39-59 lb-in. (4-7 N·m). 16-28