TM-9-2320-365-20-4 LMTV Unit Maintenance Manual M1078 Series - Volume 4 Download

Page 570 of 968

TM 9-2320-365-20-4 17-20.2 Change 2 17-5. 11K SELF-RECOVERY WINCH (SRW) CABLE REPLACEMENT/REPAIR (CONT) (6) Clean cable end thoroughly. (7) Position spelter socket (4) on fanned area of cable (1) until contact is made with top edge of wrapped wire (2). (8) Apply 1 in. (25 mm) wide bead of sealant to between bottom of spelter socket (4) and wrapped wire (2). (9) Position cable (1) and spelter socket (4) vertically in vise. WARNING WARNING CAUTION Dry cleaning solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and gloves; use only in well ventilated area; avoid contact with skin, eyes, and clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when using solvent; the flashpoint for Type I dry cleaning solvent is 100° F (38° C) and for Type II is 130° F (50° C). Failure to comply may result in serious injury or death to personnel. If personnel become dizzy while using dry cleaning solvent, immediately get fresh air and medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts eyes, immediately flush eyes with water and get immediate medical attention. Failure to comply may result in injury to personnel. Adhesive sealant MIL-S-46163 can damage your eyes. Wear safety goggles/glasses when using; avoid contact with eyes. If sealant contacts eyes, flush eyes with water and get immediate medical attention. Failure to comply may result in injury to personnel. All sealing compound to cure before adding resin. Failure to comply may result in damage to equipment.