TM-9-2320-365-20-4 LMTV Unit Maintenance Manual M1078 Series - Volume 4 Download
Page 567 of 968
TM 9-2320-365-20-4 Change 2 17-19 17-5. 11K SELF-RECOVERY WINCH (SRW) CABLE REPLACEMENT/REPAIR This task covers: a. Removal b. Spelter Socket Removal c. Spelter Socket Installation d. Installation e. Follow-On Maintenance INITIAL SETUP Equipment Conditions 11K SRW cable payed-out completely from front of vehicle (TM 9-2320-365-10). Engine shut down (TM 9-2320-365-10). Tools and Special Tools Tool Kit, Genl Mech (Item 44, Appendix C) Gloves, Welder's (Item 14, Appendix C) Goggles, Industrial (Item 15, Appendix C) Grease, Wire Rope-Exposed Gear (Item 23.1, Appendix-D) Wire, Non-Electrical (Item 72, Appendix D) Tool and Special Tool (cont) Tape, Duct (Item 67, Appendix-D) Adhesive (Item 10.1, Appendix-D) Spelter Socket Resin (Item 65.3, Appendix-D) Vice, Machinist (Item 48, Appendix-C) Frame, Hand, Hacksaw (Item 9.1, Appendix-C) Blade, Hand, Hacksaw (Item 3.1, Appendix-C) Personnel Required (3) a. Removal. (1) Remove cable wedge (1) and 11K SRW cable (2) from flange (3). (2) Pull 11K SRW cable (2) from flange (3). (3) Remove 11K SRW cable (2) from drum (4). WARNING • Wear leather gloves at all times when handling cable. Do not allow cable to slide through hands even with gloves on. Broken wires may cause injury. Failure to comply may result in injury to personnel. • Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel.