TM-9-2320-365-20-3 LMTV Unit Maintenance Manual M1078 Series - Volume 3 Download
Page 990 of 1268
TM 9-2320-365-20-3 14-2. FRONT BUMPER REPLACEMENT (CONT) b. Installation. (1) Position two side markers (1) on front bumper (2) with four screws (3) and self-locking nuts (4). (2) Tighten four self-locking nuts (4) to 18-22 lb-in. (2 N·m). (3) Position intervehicular 12 vdc (7 pin) cable (5) on front bumper (2) with two screws (6), lockwashers (7), and self-locking nuts (8). (4) Tighten two self-locking nuts (8) to 31-36 lb-in. (4 N·m). WARNING Front bumper weighs approximately 100 lbs (45 kgs). Use the aid of an assistant to install front bumper. Failure to comply may result in injury to personnel. NOTE Steps (5) and (6) require the aid of an assistant. (5) Install front bumper (2) on vehicle. (6) Install two shackles (9) on supports (10) with pins (11). (7) Install eight screws (12) on front bumper (2). (8) Connect connector P52F (13) to connector J52 (14). 14-4 Change 1