TM-9-2320-365-20-3 LMTV Unit Maintenance Manual M1078 Series - Volume 3 Download
Page 962 of 1268
TM 9-2320-365-20-3 13-18 Change 2 13-7. POWER STEERING HOSES AND TUBE REPLACEMENT (CONT) (4) Position clamp (5) on return hose (2). (5) Install return hose (2) on power steering reservoir (9). (6) Engage as many clamp tabs (7) as possible in tab windows (8) allowing little or no play between clamp (5) and return hose (2). (7) Tighten clamp (5) to 8-9 lb-in. (1 N•m). (8) Measure gap on clamp (5). CAUTION Clamp tongue must be started in clamp groove. Failure to comply may result in damage to equipment. NOTE Minimum allowable gap on clamp is 0.2 in. (0.5 cm). If gap is less than 0.2 in. (0.5 cm), remove and re-install clamp.