TM-9-2320-365-20-3 LMTV Unit Maintenance Manual M1078 Series - Volume 3 Download

Page 917 of 1268

TM 9-2320-365-20-3 12-3. WHEEL STUD REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Wheel removed (TM 9-2320-365-10). Rear spring brakes caged (para 11-6). Tools and Special Tools Tool Kit, Genl Mech (Item 44, Appendix C) Tools and Special Tools (Cont) Respirator, Air Filter (Item 29, Appendix C) Personnel Required (2) a. Removal. WARNING Spring brakes must be caged before attempting replacement of a rear axle wheel stud. Failure to comply may result in serious injury or death to personnel. Wheel drum weighs approximately 92 lbs (42 kgs). Use the aid of an assistant to help remove wheel drum from axle. Failure to comply may result in injury to personnel. Brake shoes may be covered with dust. Breathing this dust may be harmful to your health. Do not use compressed air to clean brake shoes. Wear a filter mask approved for use against brake dust. Failure to comply may result in injury to personnel. CAUTION Wheel studs and nuts on left side of vehicle have left hand threads. Nuts must be turned to the right to loosen. Wheel studs and nuts on right side of vehicles have right hand threads. Nuts must be turned to the left to loosen. Failure to comply may result in damage to equipment. NOTE Step (1) requires the aid of an assistant. (1) Remove wheel drum (1) from wheel hub (2). (2) Turn hub to position stud (3), to be replaced, at top or bottom position. (3) Knock stud (3) out through back side of wheel hub (2). 12-5