Covering the politics, Business and technology of defense - Subscribe Today

TM-9-2320-365-20-3 LMTV Unit Maintenance Manual M1078 Series - Volume 3 Download

Page 782 of 1268

TM 9-2320-365-20-3 11-5. REAR BRAKE PLUNGER ASSEMBLY REPLACEMENT/REPAIR (CONT) e. Installation. CAUTION Adjusting sleeve must bottom on the shoulder inside the plunger. Threading adjusting screw too far into adjusting sleeve will cause automatic adjuster not to function. NOTE Install plungers in same location as removed and align keyways in anchor/ adjusting plungers with hole in plunger housings. (1) Install adjusting plunger assembly (1) in plunger housing (2). NOTE Make certain grooves in pawl assembly end engage in adjusting sleeve grooves. (2) Position lockwasher (3) and pawl assembly (4) in plunger housing (2). (3) Tighten pawl assembly (4) to 15-25 lb-ft (20-34 N·m). NOTE • One anchor (solid) and one adjusting plunger must be installed in each plunger housing. • Install anchor plunger marked "L" in left plunger housing. Install anchor plunger marked "R" in right plunger housing. (4) Apply film of grease on anchor plunger (5). (5) Install and seat seal (6) and anchor plunger (5) in plunger housing (2). (6) Position lockwasher (7) and guide screw (8) in plunger housing (2). (7) Tighten guide screw (8) to 15-25 lb-ft (20-34 N·m). 11-28