TM-9-2320-365-20-3 LMTV Unit Maintenance Manual M1078 Series - Volume 3 Download
Page 778 of 1268
TM 9-2320-365-20-3 11-5. REAR BRAKE PLUNGER ASSEMBLY REPLACEMENT/REPAIR (CONT) WARNING Brake shoes may be covered with dust. Breathing this dust may be harmful to your health. Do not use compressed air to clean brake shoes. Wear a filter mask approved for use against brake dust. Failure to comply may result in injury to personnel. NOTE • Identify anchor and adjusting plunger locations prior to disassembly. • Anchor plungers and adjusting plungers are opposite each other in each plunger housing. The positions are reversed for opposite sides of the wheel. Perform the following procedure to disassemble both plunger assemblies. (2) Remove guide screw (3) and lockwasher (4) from plunger housing (5). Discard lockwasher. (3) Remove seal (6) and anchor plunger (7) from plunger housing (5). (4) Remove adjusting pawl assembly (8) and lockwasher (9) from plunger housing (5). Discard lockwasher. (5) Remove seal (10), adjusting screw (11), and adjusting plunger (12) from plunger housing (5). 11-24