TM-9-2320-365-20-3 LMTV Unit Maintenance Manual M1078 Series - Volume 3 Download
Page 763 of 1268
TM 9-2320-365-20-3 11-3. REAR BRAKE SHOES REPLACEMENT/ADJUSTMENT This task covers: a. Removal b. Inspection c. Installation d. Adjustment e. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-365-10). Wheel and tire removed (TM 9-2320-365-10). Brakes caged (para 11-6). Tools and Special Tools Tool Kit, Genl Mech (Item 44, Appendix C) Tool, Spring Removal (Item 83, Appendix B) Respirator, Air Filter (Item 29, Appendix C) Trestle, Motor Vehicle Maintenance (Item 45, Appendix C) Tools and Special Tools (Cont) Adjusting Tool, Brake Shoe (Item 2, Appendix C) Brake Adjusting Tool Support (Item E-2, Appendix E) Materials/Parts Rag, Wiping (Item 51, Appendix D) Grease, Automotive and Artillery (GAA) (Item 23, Appendix D) Lockwasher (4) (Item 102, Appendix G) Personnel Required (2) a. Removal. WARNING • Wheel drum weighs approximately 90 lbs (41 kg). Use the aid of an assistant to help remove wheel drum. Failure to comply may result in injury to personnel. • Brake shoes may be covered with dust. Breathing this dust may be harmful to your health. Do not use compressed air to clean brake shoes. Wear a filter mask approved for use against brake dust. Failure to comply may result in injury to personnel. NOTE Left and right side rear brake shoes are removed the same way. Left side shown. (1) Remove wheel drum (1) from wheel hub (2). Change 1 11-9