TM-9-2320-365-20-3 LMTV Unit Maintenance Manual M1078 Series - Volume 3 Download
Page 745 of 1268
TM 9-2320-365-20-3 Change 2 10-19 b. Installation. NOTE (1) Remove screw from axle shaft (1). (2) Align splines of axle shaft (1) with gears in differential carrier. (3) Install axle shaft (1) in wheel hub assembly (2). (4) Apply adhesive to grease cap (3). (5) Install grease cap (3) on wheel hub assembly (2). c. Follow-On Maintenance. (1) Add oil to differential carrier (Appendix H). (2) Add oil to wheel hub assembly (Appendix H). (3) Start engine (TM 9-2320-365-10). (4) Road test vehicle and check for unusual noise or vibration from axles. (5) Shut down engine (TM 9-2320-365-10). (6) Check around grease cap for oil leaks. End of Task. WARNING Perform step (1) only if axle shaft is not being replaced. Adhesives, solvents, and sealing compounds can burn easily can give off harmful vapors, and are harmful to skin and clothing. Keep away from open fire and use in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel.