TM-9-2320-365-20-3 LMTV Unit Maintenance Manual M1078 Series - Volume 3 Download
Page 734 of 1268
TM 9-2320-365-20-3 10-2. WHEEL BEARING/CENTRAL TIRE INFLATION SYSTEM (CTIS) SEAL REPLACEMENT (CONT) (10) Apply two wraps of duct tape on splined and threaded portions of spindle (12). CAUTION Use care when installing wheel end hub assembly on spindle. Failure to comply may damage CTIS seal and cause early failure of CTIS seals. (11) Install wheel end hub (2) on spindle (12). (12) Remove duct tape from spindle (12). (13) Install outer wheel bearing cone (13) in wheel end hub (2). (14) Position wheel bearing nut (14) on spindle (12). CAUTION Rotate wheel end hub to the left and to the right while tightening wheel bearing nut. Failure to comply may result in damage to equipment. (15) Tighten wheel bearing nut (14) to 50 lb-ft (68 N·m). (16) Loosen wheel bearing nut (14) one quarter turn (90- degrees). CAUTION Do not tighten wheel bearing nut more than 10-20 lb-ft (14-27 N·m). Failure to comply may result in damage to equipment. (17) Tighten wheel bearing nut (14) to 10-20 lb-ft (14-27 N·m). 10-8