TM-9-2320-365-20-3 LMTV Unit Maintenance Manual M1078 Series - Volume 3 Download
Page 728 of 1268
TM 9-2320-365-20-3 Section II. MAINTENANCE PROCEDURES 10-2. WHEEL BEARING/CENTRAL TIRE INFLATION SYSTEM (CTIS) SEAL REPLACEMENT This task covers: a. Removal b. Cleaning/Inspection c. Installation d. Follow-On Maintenance INITIAL SETUP Equipment Conditions Wheel removed (TM 9-2320-365-10). Differential spider assembly removed (para 10-3). Tools and Special Tools Tool Kit, Genl Mech (Item 44, Appendix C) Gloves, Rubber (Item 13, Appendix C) Goggles, Industrial (Item 15, Appendix C) Trestle, Motor Vehicle Maintenance (Item 45, Appendix C) Jack, Hydraulic, Hand (Item 21, Appendix C) Wrench, Torque, 0-175 lb-ft (Item 57, Appendix C) Socket, Socket Wrench (Item 70, Appendix B) CTIS Seal Driver (Item E-18, Appendix E) Wheel Hub Grease Seal Driver (Item E-19, Appendix E) Tools and Special Tools (Cont) Wheel Bearing Shim Tool Rest (Item E-10, Appendix E) Gage, Depth, Micrometer (Item 10, Appendix C) Materials/Parts Rag, Wiping (Item 51, Appendix D) Adhesive (Item 6, Appendix D) Tape, Duct (Item 74, Appendix D) Solvent, Dry Cleaning (Item 71, Appendix D) Grease, Automotive and Artillery (GAA) (Item 23, Appendix D) Seal Assembly, CTIS (2) (Item 248, Appendix G) Seal Assembly, Hub (Item 249, Appendix G) Personnel Required (2) a. Removal. WARNING Wheel drum weighs approximately 90 lbs (41 Kgs). Use the aid of an assistant to remove wheel drum. Failure to comply may result in injury to personnel or damage to equipment. NOTE Front axle and rear axle wheel bearings and CTIS seals are removed the same way. Left front axle shown. (1) Remove wheel drum (1) from wheel end hub (2). 10-2