TM-9-2320-365-20-3 LMTV Unit Maintenance Manual M1078 Series - Volume 3 Download
Page 722 of 1268
TM –9-2320-365-20-3 9-2.4 Change 2 9-2. DRIVE SHAFT AND UNIVERSAL JOINT REPLACEMENT/REPAIR (CONT) (2.1) Tighten four screws (5) to 26-35 lb-ft (35-47 N•m). (3) Tighten four screws (5). (3.1) Tighten four screws (5) to 26-35 lb-ft (35-47 N•m). (3.2) Fold tabs on four screws (5). (4) Deleted. (5) Apply lubrication to grease fittings (1). (6) Perform steps (1) through (5) on opposite end of drive shaft (3). CAUTION NOTE Perform the following step on kits equipped with screws P/N C5H5-24-39. Grease must flow from all four seals. Failure to comply may result in damage to equipment. NOTE • Perform the following step on kits equipped with shearhead screws. • Alternately tighten screws. • When correct torque is reached, bearing cap screw small hex head will break off. NOTE Perform the following two steps on bearing cups equipped with tabs.