TM-9-2320-365-20-3 LMTV Unit Maintenance Manual M1078 Series - Volume 3 Download

Page 721 of 1268

TM 9-2320-365-20-3 Change 2 9-2.3 e. Installation. (1) Install two grease fittings (1) in universal joint (2). (2) Position universal joint (2) on drive shaft (3) with two bearing cups (4) and four screws (5). WARNING CAUTION Do not use steel hammers to seat bearing cups in drive yokes. Failure to comply may result in injury to personnel or damage to equipment. Check bearing cups to ensure all needle bearings are in place prior to installation. Replace bearing cups if needle bearings are missing or out of place. Failure to comply may result in damage to equipment. NOTE Wipe end of yoke bearing bores prior to installation. NOTE There are two types of bearing cups, those with tabs and those without. Perform the following step on bearing cups not equipped with tabs.