TM-9-2320-365-20-3 LMTV Unit Maintenance Manual M1078 Series - Volume 3 Download

Page 688 of 1268

TM 9-2320-365-20-3 8-10. TRANSMISSION OIL COOLER REPLACEMENT (CONT) (13) Position flow restrictor (18) and coolant hose (15) on transmission oil cooler (1). (14) Position coolant hose (16) on transmission oil cooler (1). (15) Position radiator hose (17) on transmission oil cooler (1). CAUTION Ensure clamp tongue is started in clamp groove. Failure to comply may result in damage to equipment. (16) Engage as many clamp tabs (13) as possible in tab windows (14) allowing little or no play between clamp and coolant hose (15). (17) Tighten three clamps (11) to 12-18 lb-in. (1-2 N·m). NOTE Minimum allowable gap between ends of clamp is 0.2 in. (5 mm). If gap is less than minimum allowable, remove and re-install clamp. (18) Measure gap between ends of three clamps (11). c. Follow-On Maintenance. (1) Add coolant to radiator overflow tank (Appendix H). (2) Install radiator cap on radiator overflow tank. (3) Service transmission (Appendix H). (4) Operate vehicle and check transmission oil cooler and fittings for oil leaks (TM 9-2320-366-10-1). End of Task. 8-42 Change 1