TM-9-2320-365-20-3 LMTV Unit Maintenance Manual M1078 Series - Volume 3 Download
Page 680 of 1268
TM 9-2320-365-20-3 8-9. TRANSMISSION OIL FILTER REPLACEMENT (CONT) NOTE Perform step (3) on transmissions SN 6510069120 and higher. (3) Position gasket (4) and transmission oil filter cover (2) on transmission control module (5) with six screws (6). NOTE Perform step (4) on transmissions SN lower than 6510069120 (4) Position transmission oil filter cover (2) on trans-mission control module (5) with six screws (6). (5) Tighten six screws (6) to 38-45 lb-ft (52-61 N·m) in sequence shown. CAUTION Ensure needle bearings are aligned prior to installation of bearing cups on universal joint trunnions. Failure to comply may result in damage to equipment. (6) Position universal joint (7) in drive yoke (8) with two bearing cups (9) and four screws (10). NOTE When correct torque is reached, bearing cap screw small hex head will break off. (7) Tighten four screws (10) to 26-35 lb-ft (35-47 N·m). 8-36 Change 1