TM-9-2320-365-20-3 LMTV Unit Maintenance Manual M1078 Series - Volume 3 Download
Page 672 of 1268
TM 9-2320-365-20-3 8-8. WTEC III TRANSMISSION CONTROLS INITIAL INSTALLATION (CONT) NOTE Reference points are from inside passenger side dashboard. (11) Measure and mark a line 2.0 in. (5 cm) from point A to point B in dashboard (10). NOTE Position WTEC III transmission ECU in dashboard with mounting tabs down. (12) Position WTEC III transmission ECU (11) in dashboard (10) with single mounting tab over matchmark. CAUTION Do not position WTEC III transmission ECU on weldnuts in dashboard. Failure to comply may result in damage to equipment. (13) Match mark mounting tabs on WTEC III transmission ECU (11) with centerpunch. (14) Remove WTEC III transmission ECU (11) from dashboard (10). WARNING Wear goggles when drilling metal. Failure to comply may result in injury to personnel. (15) Drill a pilot hole at centerpunch points marked in step (13). (16) Enlarge three pilot holes in step (15) to 0.315 in. (0.8 cm). (17) Install WTEC III transmission ECU (11) under dashboard (10) with three washers (16), screws (17), washers (18), and nuts (19). 8-28