TM-9-2320-365-20-3 LMTV Unit Maintenance Manual M1078 Series - Volume 3 Download
Page 645 of 1268
TM 9-2320-365-20-3 b. Installation. (1) Install WTEC III TPSS (1) in instrument panel assembly (2). (2) Position two brackets (3) and self-locking nuts (4) on WTEC III TPSS (1). (3) Tighten two self-locking nuts (4) to 11-13 lb-in. (1-2 N·m). (4) Connect connector PX33 (5) to WTEC III TPSS connector (6). c. Calibration. NOTE WTEC III TPSS requires calibration after replacement. Calibration is accomplished in steps (1) through (4). (1) Position master power switch to on and wait for neutral (N) indication from WTEC III TPSS (TM 9-2320-365-10). (2) Position master power switch to off (TM 9-2320-365-10). (3) Perform steps (1) and (2) four more times. (4) Position master power switch to on (TM 9-2320-365-10). (5) Start engine (TM 9-2320-365-10). (6) Check VOLTS gage for charge indication (TM 9-2320- 365-10). NOTE Transmission shifting may be rough until WTEC III TPSS determines proper shift points. Operating vehicle through each gear range several times will allow WTEC III TPSS to determine proper shift points. (7) Test drive vehicle and check operation through all gear ranges several times (TM 9-2320-365-10). (8) Shut down engine (TM 9-2320-365-10). End of Task. 8-7