TM-9-2320-365-20-3 LMTV Unit Maintenance Manual M1078 Series - Volume 3 Download

Page 636 of 1268

TM 9-2320-365-20-3 7-88. LOW PRESSURE TRANSMITTER REPLACEMENT (CONT) b. Installation. NOTE Perform steps (1) through (12) on vehicle serial numbers 0001 through 7447 that have not previously had front lights cable assembly replaced. (1) Drill two holes 0.05-0.07 in. (0.127-0.178 cm) in TLR and TTR areas of boot (1). (2) Cut two pieces of insulation sleeving (2) 1.57 in. (4 cm). (3) Position two insulation sleevings (2) on wires 3024 (3) and 1616 (4). (4) Route wire 3024 (3) through hole TLR in boot (1). (5) Route wire 1616 (4) through hole TTR in boot (1). (6) Cut two pieces of insulation sleeving (5) 0.78 in. (2 cm). (7) Position two insulation sleevings (5) on wires 3024 (3) and 1616 (4). (8) Remove approximately 1/4 in. (0.6 cm) of insulation from wires 3024 (3) and 1616 (4). (9) Install terminal lug TL201 (6) on wire 3024 (3). (10) Install terminal lug TL202 (7) on wire 1616 (4). (11) Position two insulation sleevings (5) on terminal lugs TL201 (6) and TL202 (7). (12) Shrink two insulation sleevings (2 and 5) on TL201 (6) and TL202 (7). 7-382 Change 1