TM-9-2320-365-20-3 LMTV Unit Maintenance Manual M1078 Series - Volume 3 Download

Page 604 of 1268

TM 9-2320-365-20-3 7-82. START AND CHARGING CABLE ASSEMBLY REPLACEMENT (CONT) NOTE Perform steps (13.1) through (14) on start and charging cable assemblies equipped with P81 connector. (13.1) Cut connector P81 (16) from start and charging cable assembly (1). (13.2) Remove band marker (17) from start and charging cable assembly (1). NOTE Remove electrical tape and insulation sleeving as required. (13.3) Remove convoluted tubing (17.1) from two wires (17.2 and 17.3). NOTE Measure wires from body of start and charging cable assembly. (13.4) Cut wire (17.2) to 3 in. (7.6 cm) in length. (13.5) Cut wire (17.3) to 4 in. (10.2 cm) in length. (13.6) Remove 0.38 in. (1 cm) of insulation from two wires (17.2 and 17.3). (13.7) Cut insulation sleeving (17.4) 1.5 in. (3.8 cm). (13.8) Position insulation sleeving (17.4) on wire (17.3). (13.9) Install conductor splice (17.5) on two wires (17.2 and 17.3). (13.10) Install insulation sleeving (17.4) on conductor splice (17.5). NOTE Install electrical tape as required. (14) Install convoluted tubing (17.1) on two wires (17.2 and 17.3). 7-350.2 Change 1