TM-9-2320-365-20-3 LMTV Unit Maintenance Manual M1078 Series - Volume 3 Download
Page 440 of 1268
TM 9-2320-365-20-3 7-47. BATTERY BOX REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Batteries removed (para 7-46). NATO power cable removed (para 7-63). Wet tank removed (para 23-7). Secondary and primary air tanks removed (para 11- 20). Tools and Special Tools Tool Kit, Genl Mech (Item 44, Appendix C) Wrench, Torque, 0-175 lb-ft (Item 57, Appendix C) Wrench, Torque, 0-200 lb-in. (Item 58, Appendix C) Drill, Portable, Electric (Item 7, Appendix C) Drill Set, Twist (Item 6, Appendix C) Goggles, Industrial (Item 15, Appendix C) Tool Kit, Blind Rivet (Item 43, Appendix C) Socket Set, Socket Wrench (Item 34, Appendix C) Wrench Set, Socket (Item 48, Appendix C) Tools and Special Tools (Cont) Wrench, Torque, 0-600 lb-ft (Item 59, Appendix C) Adapter, Socket Wrench (Item 1, Appendix C) Materials/Parts Lockwasher (2) (Item 85, Appendix G) Nut, Self-Locking (4) (Item 144, Appendix G) Washer, Flat (10) (Item 270.1, Appendix G) Tape, Adhesive, Rubber (Item 72.1, Appendix D) Rivet, Blind (Item 223.1, Appendix G) Rivet, Blind (Item 223.2, Appendix G) Personnel Required (3) a. Removal. (1) Remove 16 nuts (1), screws (2), and 32 washers (3) from battery tray (4). (2) Remove battery tray (4) from battery box (5). (3) Deleted. WARNING Wear appropriate eye protection when removing rivets. Failure to comply may result in injury to personnel. (3.1) Remove six rivets (6), washers (6.1), and two latches (6.2) from battery box (5). (3.2) Remove six band clamps (6.3) from battery box (5). 7-196 Change 1