TM-9-2320-365-20-3 LMTV Unit Maintenance Manual M1078 Series - Volume 3 Download
Page 428 of 1268
TM 9-2320-365-20-3 7-184 Change 2 7-45. BATTERY TESTER REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-365-10). Battery box cover removed (TM 9-2320-365-10). Tools and Special Tools Goggles, Industrial (Item 15, Appendix C) Apron, Rubber (Item 3, Appendix C) Gloves, Rubber (Item 13, Appendix C) Puller, Battery Terminal (Item 28, Appendix C) Tool Kit, Genl Mech (Item 44, Appendix C) Materials/Parts Dispenser, Pressure Sensitive Adhesive Tape (Item 21, Appendix D) Grease, Automotive and Artillery (GAA) (Item 23, Appendix D) Lockwasher (Item 78, Appendix G) a. Removal. (1) Remove nut (1) and lockwasher (2) from battery ground cable (3). Discard lockwasher. (2) Deleted. (3) Remove terminal lugs TL50A (5), TL48 (6), and battery tester terminal lug (7) from battery ground cable (3). WARNING • Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. Batteries can explode from a spark. Battery acid is harmful to skin and eyes. Always wear eye protection when working with batteries. • Negative battery terminals must be disconnected first. Failure to comply may result in serious injury or death to personnel. NOTE Tag cables and connection points prior to disconnecting.