TM-9-2320-365-20-3 LMTV Unit Maintenance Manual M1078 Series - Volume 3 Download
Page 258 of 1268
TM 9-2320-365-20-3 7-20 Change 2 7-5. 100 AMP VOLTAGE REGULATOR REPLACEMENT (CONT) (5) Apply electrical tape to terminal lug TL110 (6). (5.1) Cut terminal lug TL110 (6) from engine control cable assembly wire (6.1) (6) Remove dust boot (7) from engine control cable assembly wire (6.1). (7) Apply electrical tape to engine control cable assembly wire (6.1) so wire doesn’t interfere with engine or alternator operations. (8) Position terminal lug TL35 (10) on voltage regulator (2) with washer (11), and self-locking nut (12). (9) Tighten self-locking nut (12) to 25 lb-in. (3 N m). (10) Position dust boot (13) on terminal lug TL35 (10). c. Follow-On Maintenance (1) Lower cab (TM 9-2320-365-10). (2) Connect batteries (para 7-48). (3) Start engine (TM 9-2320-365-10). (4) Check VOLTS gage for charge indication (TM 9-2320- 365-10). (5) Shut down engine (TM 9-2320-365-10). End of Task. NOTE • Perform step (5) if replacing alternator P/N N1506-1 (12420852) with alternator P/N N1509-1 (12422863). • Install plastic cable ties to terminal lug TL110 and tie wire away from alternator. NOTE Perform steps (5.1) through (7) on alternator N1506-1 (12420852).