TM-9-2320-365-20-3 LMTV Unit Maintenance Manual M1078 Series - Volume 3 Download
Page 233 of 1268
TM 9-2320-365-20-3 6-13. DRIVE BELT AND TENSION PULLEY REPLACEMENT (CONT) NOTE Perform steps (9) through (13) on vehicles serial numbers 8426 and lower that have had fan clutch replaced. (9) Install grommet (12) on engine fan (13). (10) Install fan support plate (14) on engine fan (13). CAUTION Ensure engine fan is positioned with mark facing forward. Failure to comply may result in damage to equipment. (11) Position engine fan (13) and fan support plate (14) on fan clutch assembly (15) with six washers (16), lockwashers (17), and screws (18). (12) Tighten six screws (18) to 15 lb-ft (20 N·m) in sequence shown. (13) Re-tighten six screws (18) to 22-32 lb-ft (30-44 N·m) in sequence shown. WARNING Adhesives, solvents, and sealing com- pounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing. Keep away from open fire and use in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel. (14) Apply antiseize compound to threads of fitting (19). (15) Install fitting (19) on fan clutch assembly (15). (16) Connect air hose (20) to fitting (19). c. Follow-On Maintenance. Install top radiator fan shroud (para 6-4). End of Task. Change 1 6-73