TM-9-2320-365-20-3 LMTV Unit Maintenance Manual M1078 Series - Volume 3 Download

Page 204 of 1268

TM 9-2320-365-20-3 6-46 Change 2 6-8. PERSONNEL HEATER HOSES REPLACEMENT (CONT) (11) Lower cab (TM 9-2320-365-10). (12) Position heater outlet hose (6) on return fitting (10). (13) Position heater inlet hose (7) on supply fitting (11). (14) Engage as many clamp tabs (4) as possible in tab windows (5) allowing little or no play between clamps (2) and heater outlet hose (6) and heater inlet hose (7). (15) Tighten two clamps (2) to 8-9-in. (1 N•m). (16) Raise cab (TM 9-2320-365-10). (17) Measure gap on two clamps (2). NOTE Heater outlet hose is marked with an arrow pointing down. NOTE Heater inlet hose is marked with an arrow pointing up. NOTE Minimum allowable gap on clamp is 0.1 in. (0.3 cm). If gap is less than 0.1 in. (0.3 cm), remove and re-install clamp.