TM-9-2320-365-20-3 LMTV Unit Maintenance Manual M1078 Series - Volume 3 Download
Page 140 of 1268
TM 9-2320-365-20-3 Section II. MAINTENANCE PROCEDURES 5-2. MUFFLER AND EXHAUST HEAT SHIELDS REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-365-10). Tools and Special Tools Goggles, Industrial (Item 15, Appendix C) Tool Kit, Genl Mech (Item 44, Appendix C) Drill, Electric, Portable (Item 7, Appendix C) Drill Set, Twist (Item 6, Appendix C) Drill, Twist (Item 8, Appendix C) Wrench, Torque, 0-200 lb-in. (Item 58, Appendix C) Wrench, Torque, 0-175 lb-ft (Item 57, Appendix C) Socket Set, Socket Wrench (Item 35, Appendix C) Materials/Parts Nut, Self-Locking (2) (Item 141, Appendix G) Nut, Self-Locking (4) (Item 138, Appendix G) Nut, Self-Locking (Item 140, Appendix G) Nut, Self-Locking (2) (Item 119, Appendix G) Nut, Self-Locking (2) (Item 149, Appendix G) Washer, Flat (4) (Item 271, Appendix G) Screw, Cap (2) (Item 238, Appendix G) Grommet, Nonmetallic (6) (Item 48, Appendix G) Personnel Required (2) WARNING • Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. • Ensure exhaust system is cool before performing maintenance. Failure to comply may result in injury to personnel. • Do not operate vehicle with muffler removed. Toxic exhaust fumes may enter cab, resulting in serious injury or death to personnel. a. Removal. (1) Remove self-locking nut (1) from clamp (2). Discard self- locking nut. (2) Disconnect exhaust pipe (3) from muffler (4). 5-2