TM-9-2320-365-20-3 LMTV Unit Maintenance Manual M1078 Series - Volume 3 Download

Page 135 of 1268

TM 9-2320-365-20-3 4-22. CHECKING AND STENCILING HIGH/LOW HAND THROTTLE POSITIONS This task covers: a. Checking High/Low Hand Throttle Positions b. Stenciling High/Low Hand Throttle Positions Equipment Conditions Engine shut down (TM 9-2320-365-10). Tools and Special Tools STE/ICE-R (Item 39, Appendix C) Gloves, Rubber (Item 13, Appendix C) Respirator, Air Filter (Item 29, Appendix C) Materials/Parts Rubber Stamp Set, Fixed Type (Item 54, Appendix D) Polyurethane Coating (Item 49, Appendix D) Ink, Marking Stencil (Item 27, Appendix D) Inking Pad, Rubber Stamp (Item 28, Appendix D) References TM 9-4910-571-12&P TB 43-0209 a. Checking High/Low Hand Throttle Positions. (1) Connect STE/ICE-R to DCA connector (1). (2) Start engine (TM 9-2320-365-10). (3) Position HAND THROTTLE lever (2) so that upper edge of lever is even with line below L setting. NOTE Acceptable engine RPM with HAND THROTTLE lever at L setting is 1250-1450 RPM. (4) Perform STE/ICE-R test #10. 4-103