TM-9-2320-365-20-3 LMTV Unit Maintenance Manual M1078 Series - Volume 3 Download
Page 1036 of 1268
TM TM 9-2320-365-20-3 9-2320-365-20-3 15-4. REAR AXLE SHOCK ABSORBER REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-365-10). Tools and Special Tools Goggles, Industrial (Item 15, Appendix C) Tool Kit, Genl Mech (Item 44, Appendix C) Wrench, Torque, 0-600 lb-ft (Item 59, Appendix C) Tools and Special Tools (Cont) Socket Set, Impact (Item 33, Appendix C) Wrench Set, Socket (Item 48, Appendix C) Materials/Parts Nut, Self-Locking (2) (Item 144, Appendix G) WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. a. Removal. (1) Remove self-locking nut (1), bolt (2), and washer (3) from upper bracket (4). Discard self-locking nut. (2) Remove self-locking nut (5), bolt (6), two washers (7), and shock absorber (8) from lower bracket (9). Discard self-locking nut. b. Installation. (1) Position shock absorber (8) in upper bracket (4) with washer (3), bolt (2), and self-locking nut (1). (2) Extend or compress shock absorber (8) length to align with holes in lower bracket (9). (3) Position shock absorber (8) in lower bracket (9) with two washers (7), bolt (6), and self-locking nut (5). (4) Tighten self-locking nut (1) to 196-240 lb-ft (265-325 N·m). (5) Tighten bolt (6) to 373-454 lb-ft (505-615 N·m). End of Task. 15-6 15-6