TM-9-2320-365-20-3 LMTV Unit Maintenance Manual M1078 Series - Volume 3 Download
Page 1028 of 1268
TM 9-2320-365-20-3 15-2 Change 2 Section II. MAINTENANCE PROCEDURES 15-2. RESILIENT MOUNT AND MECHANICAL STOP REPLACEMENT This task covers: a. Mechanical Stop Removal b. Mechanical Stop Installation c. Resilient Mount Removal d. Resilient Mount Installation e. Front Angle Bracket Resilient Mount Removal f. Front Angle Bracket Resilient Mount Installation g. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-365-10). Cab raised (for front angle bracket resilient mount) (TM 9-2320-365-10). Tools and Special Tools Goggles, Industrial (Item 15, Appendix C) Tool Kit, Genl Mech (Item 44, Appendix C) Wrench, Torque, 0-175 lb-ft (Item 57, Appendix C) Tools and Special Tools (Cont) Crowfoot Attachment, Socket Wrench (Item 5, Appendix B) Vise, Machinist (Item 46, Appendix C) Materials/Parts Nut, Self-Locking (2) (Item 144, Appendix G) Washer, Spring (Item 276, Appendix G) Washer, Spring (Item 280, Appendix G) a. Mechanical Stop Removal. Remove two self-locking nuts (1), bolts (2), and mechanical stop (3) from frame (4). Discard self-locking nuts. b. Mechanical Stop Installation. (1) Position mechanical stop (3) on frame (4) with two bolts (2) and self-locking nuts (1). (2) Tighten two self-locking nuts (1) to 118-148 lb-ft (160-201 N•m). WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. NOTE Both mechanical stops are removed the same way. Right rear side shown. NOTE Both mechanical stops are installed the same way. Right rear side shown.