Sign up to sell your inventory with NSN Lookup

TM-9-2320-365-20-3 LMTV Unit Maintenance Manual M1078 Series - Volume 3 Download

Page 1024 of 1268

TM 9-2320-365-20-3 14-36 Change 2 14-6. PINTLE HOOK REPLACEMENT (CONT) b. Installation. NOTE (1) Position support (1) on rear crossmember (2) with four screws (3) and self-locking nuts (4). (2) Tighten four self-locking nuts (4) to 195-239 lb-ft (265-325 N•m). (3) Apply coat of grease to shaft of pintle hook (5). (4) Install pintle hook (5) in rear crossmember (2) with washer (6) and nut (7). (5) Adjust nut (7) until clearance is 0.003-0.017 in. (0.007-0.043 cm) with alignment holes lined up between nut and pintle hook (5). (6) Install cotter pin (8) in nut (7). c. Follow-On Maintenance. Lubricate pintle hook (TM 9-2320-365-20). End of Task. WARNING CAUTION All pintle hooks are installed the same way. M1078 shown. Clearance between washer and support must be 0.003-0.017 in. (0.007-0.043 cm). Failure to comply may result in damage to equipment. Pintle hook weighs approximately 65 lbs (30 kgs). Attach a suitable lifting device prior to installation. Failure to comply may result in injury to personnel or damage to equipment.