TM-9-2320-365-20-3 LMTV Unit Maintenance Manual M1078 Series - Volume 3 Download
Page 1023 of 1268
TM 9-2320-365-20-3 Change 2 14-35 14-6. PINTLE HOOK REPLACEMENT This task covers a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-365-10) Tools and Special Tools Tool Kit, Genl Mech (Item 44, Appendix C) Goggles, Industrial (Item 15, Appendix C) Wrench, Torque, 0-600 lb-ft (Item 59, Appendix C) Wrench Set, Socket (Item 48, Appendix C) Materials/Parts Nut, Self-locking (4) (Item 144, Appendix G) Pin, Cotter (Item 208.1, Appendix G) Grease, Automotive and Artillery (GAA) (Item 23, Appendix D) Personnel Required (2) a. Removal. NOTE (1) Remove cotter pin (1) from nut (2). Discard cotter pin. (2) Remove nut (2) and washer (3) from pintle hook (4). (3) Remove pintle hook (4) from rear crossmember (5). (4) Remove four self-locking nuts (6), screws (7), and support (8) from rear crossmember (5). Discard self-locking nuts. WARNING WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. All pintle hooks are removed the same way. M1078 shown. Pintle hook weighs approximately 65 lbs (30 kgs). Attach a suitable lifting device prior to removal. Failure to comply may result in injury to personnel or damage to equipment.