TM-9-2320-365-20-2 LMTV Unit Maintenance Manual M1078 Series - Volume 2 Download
Page 985 of 1432
TM 9-2320-365-20-2 TM 9-2320-365-20-2 TM 9-2320-365-20-2 TM 9-2320-365-20-2 TM 9-2320-365-20-2 WINCH CONTROL VALVE PRESSURE TEST (12) Disconnect STE/ICE-R and tee. (13) Connect hose fitting to port V1. (14) Disconnect hose (below elbow) from port V2. (15) Connect STE/ICE-R with tee between hose and port V2. (16) Start engine (TM 9-2320-365-10). (17) Position PTO and WINCH POWER switches to on (TM 9-2320-365-10). (18) Perform STE/ICE-R test #51 and toggle WINCH IN/OUT switch to OUT (TM 9-4910-571-12&P). (19) Check if pressure reading is between 2000-2100 psi (13790-14480 kPa). (20) If pressure is lower than 2000 psi, notify DS Maintenance. (21) Release load and retrieve cable (TM 9-2320-365-10). (22) Position WINCH POWER and PTO switches to off (TM 9-2320-365-10). (23) Disengage winch clutch (TM 9-2320-365-10). (24) Shut down engine (TM 9-2320-365-10). (25) Disconnect STE/ICE-R and tee. (26) Connect hose fitting to port V2. (1) Disconnect hose from fitting below elbow at port V1 (on side of 11K self-recovery winch toward front of vehicle). (2) Connect STE/ICE-R with tee between port V1 and hose. (3) Start engine (TM 9-2320-365-10). (4) Attach stall load to winch cable (TM 9-2320-365-10). (5) Position PTO switch and WINCH POWER switch to ON (TM 9-2320-365-10). (6) Engage winch clutch (TM 9-2320-365-10). (7) Perform STE/ICE-R test #51 and toggle WINCH IN/OUT switch to IN position and hold (TM 9-4910-571-12&P). (8) Check if pressure reading is between 2000-2100 psi (13790-14480 kPa) on STE/ICE-R. (9) If pressure is less than 2000 psi (13790 kPa), notify DS Maintenance. (10) Position WINCH POWER and PTO switches to off (TM 9-2320-365-10). (11) Shut down engine (TM 9-2320-365-10). 2-1949 2-1949 2-1949 2-1949 2-1949