TM-9-2320-365-20-2 LMTV Unit Maintenance Manual M1078 Series - Volume 2 Download
Page 983 of 1432
TM 9-2320-365-20-2 TM 9-2320-365-20-2 TM 9-2320-365-20-2 TM 9-2320-365-20-2 TM 9-2320-365-20-2 INPUT FLOW TEST WARNING Wear approved eye protection when performing pressure checks. Failure to comply may result in oil getting into eyes. If oil contacts eyes, seek medical attention immediately. Fuel and oil are slippery and can cause falls. Wipe up spilled fuel or oil with rags. Failure to comply may result in injury to personnel. (1) Place drain pan under control valve. (2) Disconnect hose from port P of winch control valve. (3) Connect STE/ICE-R with 5/8 in. tee and adapter kit between hose fitting and port P. (4) Start engine (TM 9-2320-365-10). (5) Position PTO switch to on (TM 9-2320-365-10). (6) Attach stall load to winch cable (TM 9-2320-365-10). (7) Position WINCH POWER switch to on (TM 9-2320-365-10). (8) Engage winch clutch (TM 9-2320-365-10). (9) Toggle WINCH IN/OUT switch to IN (TM 9-2320-365-10) and perform STE/ICE-R test #51 (TM 9-4910-574-12&P) and note pressure reading. (10) Check if pressure is 2000-2100 psi (13790-14480 kPa), if pressure is lower than 2000 psi (13790 kPa), notify DS Maintenance. (11) Position WINCH POWER and PTO switches to off (TM 9-2320-365-10). (12) Shut down engine (TM 9-2320-365-10). (13) Disconnect STE/ICE-R, tee, and adapter kit. (14) Connect hose fitting to port P. (15) Remove drain pan. Drop hydraulic pressure to zero before disconnecting any hydraulic hoses, tubes or fittings. Failure to comply may result in injury to personnel. 2-1947 2-1947 2-1947 2-1947 2-1947