TM-9-2320-365-20-2 LMTV Unit Maintenance Manual M1078 Series - Volume 2 Download
Page 97 of 1432
TM 9-2320-365-20-2 TM 9-2320-365-20-2 TM 9-2320-365-20-2 TM 9-2320-365-20-2 TM 9-2320-365-20-2 2-1151 2-1151 2-1151 2-1151 2-1151 CONTINUITY TEST (1) Disconnect AC power (TM 9-2320-365-10). (2) Remove six screws and cover from 110/208 VAC POWER DISTRIBUTION PANEL. (3) Loosen screw in terminal board TB4. (4) Remove wire 1499K from terminal board TB4. (5) Set multimeter to ohms. (6) Connect positive (+) probe of multimeter to wire 1499K in 110/208 VAC POWER DISTRIBUTION PANEL. (7) Connect negative (-) probe of multimeter to wire 1499K in lighting fixture DS83 and note reading on multimeter. (8) If continuity is not present, repair or replace wire 1499K (para 2-40). (9) If continuity is present, repair or replace wire 3085B (para 2-40). (9) Install ballast cover on lighting fixture DS83. (10) Install two fluorescent lamps in lighting fixture DS83. (11) Install tube lock holder at each end of two fluorescent lamps. (12) Install diffuser on lighting fixture DS83. (13) Install wire 1499K on terminal board TB4. (14) Tighten screw in terminal board TB4. (15) Install cover on 110/208 VAC POWER DISTRIBUTION PANEL with six screws. (16) Position circuit breaker CB1 to ON (TM 9-2320-365-10). (17) Close door on 110/208 VAC POWER DISTRIBUTION PANEL (TM 9-2320-365-10). (18) Connect AC power (TM 9-2320-365-10).