TM-9-2320-365-20-2 LMTV Unit Maintenance Manual M1078 Series - Volume 2 Download
Page 559 of 1432
Wear approved eye protection when performing transmission pressure checks. If oil contacts eyes, seek medical attention immediately. Failure to comply may result in injury to personnel. WARNING Change 1 2-1565 TM 9-2320-365-20-2 PRESSURE TEST (1) Place drain pan under transmission tap. (2) Remove main pressure tap plug and preformed packing from control valve assembly. (3) Connect tube to boss adapter, hose, and pipe to tube adapter to main pressure tap. (4) Perform STE/ICE-R Test #50 (TM 9-4910- 571-12&P). (5) Start engine (TM 9-2320-365-10) and run at idle. (6) With parking brake applied, position WTEC III TPSS to R position then to N position while assistant checks reading on STE/ICE-R. (7) Shut down engine (TM 9-2320-365-10). (8) If main oil pressure is low, notify DS Maintenance. (9) Remove pipe to tube adapter, hose, and tube to boss from main pressure tap. (10) Position preformed packing and main pressure tap plug in control valve module. (11) Tighten main pressure tap plug to 84-120 lb-in. (9-14 N·m).