TM-9-2320-365-20-2 LMTV Unit Maintenance Manual M1078 Series - Volume 2 Download
Page 525 of 1432
(1) Set multimeter to ohms. (2) Connect positive (+) prove of multimeter to connector P119h. (3) Connect negative (-) probe of multimeter to connector P119j and note reading on multimeter. (4) If resistance is high (20,000 ohms or higher), replace WTEC III transmission ECU (para 8-7). (5) If resistance is low (less than 20,000 ohms), notify DS maintenance. (6) Install instrument panel assembly (para 7-18). (7) Connect connector P119 to connector J119. (8) Position front grille on cab with washer and screw. (9) Position two washers and screws in front grille. (10) Tighten screw to 48-60 lb-in. (5-7 N·m). (11) Tighten two screws to 24 lb-in. (3 N·m). (12) Connect connector P114 to WTEC III transmission ECU. (13) Connect connector clamp on connector P114. (14) Install kick panel (para 16-3). (15) Clear diagnostic codes (para 8-5). RESISTANCE TEST Change 1 2-1531 TM 9-2320-365-20-2