TM-9-2320-365-20-2 LMTV Unit Maintenance Manual M1078 Series - Volume 2 Download
Page 473 of 1432
CAUTION Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. CONTINUITY TEST Change 1 2-1483 TM 9-2320-365-20-2 (1) Connect connector P116 to WTEC II VIM. (2) Tighten screw in connector P116. (3) Remove instrument panel assembly for access (para 7-15). (4) Disconnect connector J115 from WTEC II TEPSS. (5) Set multimeter ohms. (6) Connect positive (+) probe of multimeter to connector P115 socket 2. (7) Connect negative (-) probe of multimeter to connector J115 socket 11 and note reading on multimeter. (8) If continuity is not present, replace WTEC II cab transmission harness (para 7-86). (9) If continuity is present, replace WTEC II TEPSS (para 8-2). (10) Install kick panel (para 16-3). (11) Connect batteries (para 7-48).