Covering the politics, Business and technology of defense - Subscribe Today

TM-9-2320-365-20-2 LMTV Unit Maintenance Manual M1078 Series - Volume 2 Download

Page 455 of 1432

CAUTION Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. CONTINUITY TEST (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to WTEC II connector pin C1. (3) Connect negative (-) probe of multimeter to WTEC II connector pin S1 and note reading on multimeter. (4) If continuity is not present, go to step 13 of this fault. TM 9-2320-365-20-2 Change 1 2-1482.25