TM-9-2320-365-20-2 LMTV Unit Maintenance Manual M1078 Series - Volume 2 Download
Page 431 of 1432
CONTINUITY TEST (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to connector J115-9. (3) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (4) Connect positive (+) probe of multimeter to connector J115-18. (5) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (6) If continuity is not present, replace WTEC II cab transmission harness (para 7-86). (7) If continuity is present, replace WTEC II TEPSS (para 8-2). (8) Connect connector J115 (top connector) to WTEC II TEPSS. (9) Install instrument panel assembly (para 7-15). (10) Clear diagnostic codes (para 8-4). Change 1 2-1482.1 TM 9-2320-365-20-2