TM-9-2320-365-20-2 LMTV Unit Maintenance Manual M1078 Series - Volume 2 Download
Page 413 of 1432
WARNING Change 1 2-1465 TM 9-2320-365-20-2 PRESSURE TEST (1) Position drain pan under pressure tap. (2) Remove main pressure tap plug and preformed packing from control valve module. (3) Connect tube to boss adapter, hose, and pipe to tube adapter to clutch pressure tap. (4) Start engine (TM 9-2320-365-10) and run at idle. (5) Perform STE/ICE-R Test #50 (TM 9-4910-571-12&P). (6) With parking brake applied, position WTEC II TEPSS to R position then to N position while assistant checks reading on STE/ICE-R. (7) Shut down engine (TM 9-2320-365-10). (8) If main oil pressure is low, notify DS Maintenance. (9) Remove pipe to tube adapter, hose, and tube to boss adapter from main pressure tap. (10) Position preformed packing and main pressure tap plug in control valve module. (11) Tighten main pressure tap plug to 84-120 lb-in. (9-14 N·m). (12) Remove drain pan under pressure tap. Wear approved eye protection when performing transmission pressure checks. If oil contacts eyes, seek medical attention immediately. Failure to comply may result in injury to personnel.