TM-9-2320-365-20-2 LMTV Unit Maintenance Manual M1078 Series - Volume 2 Download
Page 381 of 1432
(10) Connect negative (-) probe of multimeter to connector J119Z and note reading on multimeter. (11) If continuity is not present from connector J115-1 to connector J119a and J119Z, replace WTEC II cab transmission harness (para 7-86). (12) If continuity is present, replace WTEC II TEPSS (para 8-2). (13) Install instrument panel assembly (para 7-15). (14) Connect connector P119 to connector J119. (15) Position front grille on cab with washer and screw. (16) Position two washers and screws in front grille. (17) Tighten screw to 48-60 lb-in. (5-7 N·m). (18) Tighten two screws to 24 lb-in. (3 N·m). (19) Clear diagnostic codes (para 8-4). (1) Remove two screws and washers from front grille. (2) Remove screw and washer from front grille. (3) Remove front grille from cab. (4) Disconnect connector P119 from connector J119. (5) Remove instrument panel assembly for access (para 7-15). (6) Disconnect connector J115 (top connector) from WTEC II TEPSS. (7) Set multimeter to ohms. (8) Connect positive (+) probe of multimeter to connector J115-1. (9) Connect negative (-) probe of multimeter to connector J119a and note reading on multimeter. CONTINUITY TEST TM 9-2320-365-20-2 Change 1 2-1435