TM-9-2320-365-20-2 LMTV Unit Maintenance Manual M1078 Series - Volume 2 Download
Page 363 of 1432
TM 9-2320-365-20-2 Change 1 2-1417 Sub Code Sub Code Meaning 11 22 44 66 88 99 1st 2nd 4th 6th N1 N2/N4 Range VER Range VER Range VER Range VER Range VER Range VER Table 2-24. Sub Code Range WARNING CAUTION CLUTCH PRESSURE TEST Loose or dirty connectors may cause intermittent loss of power to transmission ECU and diagnostic codes to be logged. Ensure that all connectors are clean and tight before performing troubleshooting. Failure to comply may result in incorrect test results. Wear approved eye protection when performing transmission pressure checks. If oil contacts eyes, seek medical attention immediately. Failure to comply may result in injury to personnel. (12) Tighten C3 pressure tap plug to 84-120 lb-in. (9-14 N·m). (13) Remove drain pan under C3 pressure tap. (14) Install front and rear propeller shafts (para 9-2). (1) Remove front and rear propeller shafts (para 9-2). (2) Position drain pan under C3 pressure tap plug. (3) Remove C3 pressure tap plug and preformed packing from control valve module. Discard preformed packing. (4) Connect tube to boss adapter, hose, and pipe to tube adapter to C3 pressure tap. (5) Perform STE/ICE-R Test #50 (TM 9-4910-571-12&P). (6) Start engine (TM 9-2320-365-10) and run at idle. (7) With parking brake applied, make shift indicated by sub code while assistant notes reading on STE/ICE-R. (8) If pressure does not drop to zero in selected range indicated by code values, notify DS Maintenance. (9) Shut down engine (TM 9-2320-365-10). (10) Remove pipe to tube adapter, hose, and tube to boss adapter from C3 pressure tap. (11) Position preformed packing and C3 pressure tap plug in control valve module.