TM-9-2320-365-20-2 LMTV Unit Maintenance Manual M1078 Series - Volume 2 Download

Page 347 of 1432

CONTINUITY TEST CAUTION NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. TM 9-2320-365-20-2 Loose or dirty connectors may cause intermittent loss of power to transmission ECU and diagnostic codes to be logged. Ensure that all connectors are clean and tight before performing troubleshooting. Failure to comply may result in incorrect test results. Sub Code Jumper Across 12 13 14 15 16 21 22 23 24 26 J119M to J119B J119T to J119N J119C to J119V J119W to J119B J119U to J119N J119F to J119H J119D to J119V J119P to J119S J119J to J119B J119K to J119A Connector J114 Positive (+) Probe J114-2 J114-21 J114-30 J114-2 J114-21 J114-10 J114-30 J114-22 J114-2 J114-1 Negative (-) Probe J114-20 J114-28 J114-3 J114-31 J114-29 J114-7 J114-4 J114-27 J114-11 J114-16 Table 2-18. WTEC II Cab Transmission Harness Transmission Solenoid Test Points Change 1 2-1401 (1) Remove two screws and washers from front grille. (2) Remove screw and washer from front grille. (3) Remove front grille from cab. (4) Disconnect connector P119 from connector J119. (5) Remove instrument panel assembly for access (para 7-15). (6) Disconnect connector J114 (bottom connector) from WTEC II TEPSS. (7) Install jumper wire on connector J119 for appropriate sub code. Refer to Table 2-18. WTEC II Cab Transmission Harness Transmission Solenoid Test Points. (8) Set multimeter to ohms. (9) Connect positive (+) probe of multimeter to connector J114. Refer to Table 2-18. WTEC II Cab Transmission Harness Transmission Solenoid Test Points. (10) Connect negative (-) probe of multimeter to connector J114 and note reading on multimeter. Refer to Table 2-18. WTEC II Cab Transmission Harness Transmission Solenoid Test Points. (11) Connect negative (-) probe of multimeter to all other sockets in connector J115, one at a time, and note reading on multimeter. (12) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (13) If continuity is not present in step 10, or continuity is present in step 11 or step 12, replace WTEC II cab transmission harness (para 7-86). (14) Connect connector J114 to WTEC II TEPSS. (15) Install instrument panel assembly (para 7-15).