TM-9-2320-365-20-2 LMTV Unit Maintenance Manual M1078 Series - Volume 2 Download
Page 175 of 1432
TM 9-2320-365-20-2 TM 9-2320-365-20-2 TM 9-2320-365-20-2 TM 9-2320-365-20-2 TM 9-2320-365-20-2 2-1229 2-1229 2-1229 2-1229 2-1229 VOLTAGE TEST Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. WARNING (1) Push in circuit breaker CB11 (TM 9-2320-365-10). (2) Push in circuit breaker CB10 (TM 9-2320-365-10). (3) Position INTERIOR LIGHTS switch S32 to ON (TM 9-2320-365-10). (4) Set multimeter to volts dc. (5) Connect positive (+) probe of multimeter to pin 1 of P connector. Refer to Table 2-14. M1079 Blackout Light Locations and Connector Numbers. (6) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (7) If 24 vdc is not present, repair or replace wire 1505(B) (para 2-40). (8) If 24 vdc is present, repair or replace wire 3086 (para 2-40). (9) Position INTERIOR LIGHTS switch S32 to OFF (TM 9-2320-365-10). (10) Pull out circuit breaker CB10 (TM 9-2320-365-10). (11) Pull out circuit breaker CB11 (TM 9-2320-365-10). (12) Install blackout light (para 16-58).