TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 999 of 1760
TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 2-613 2-613 2-613 2-613 2-613 WARNING Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. VOLTAGE TEST (1) Remove PDP cover (para 16-2). (2) Remove three screws and washers from PDP. (3) Remove three screws from PDP. (4) Lift PDP outward to gain access. (5) Disconnect connector J27 from connector P27. (6) Set multimeter to volts dc. (7) Connect positive (+) probe of multimeter to J27-7. (8) Connect negative (-) probe of multimeter to ground. (9) Position main light switch to BO DRIVE (TM 9-2320-365-10) and note reading on multimeter. (10) If 12 vdc is not present, repair wire 19 (para 2-40) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (11) Position main light switch to OFF (TM 9-2320-365-10). (12) Connect connector J27 to connector P27. (13) Install PDP on dashboard with three screws. (14) Install three washers and screws in PDP. (15) Install PDP cover (para 16-2).