TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 969 of 1760
WARNING Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuits and cause severe burns or electrical shock. VOLTAGE TEST (1) Remove PDP cover (para 16-2). (2) Remove circuit breaker CB80 from PDP. (3) Set multimeter to volts DC. (4) Connect positive (+) probe of multimeter to circuit breaker CB80 socket 1. (5) Connect negative (-) probe of multimeter to ground. (6) Position main light switch to SER DRIVE (TM 9-2320-365-10) and note reading on multimeter. (7) If 12 VDC is not present, go to 11 of this fault. (8) If 12 VDC is present, repair wire 21 from circuit breaker CB80 socket 2 on PDP to connector J51 pin 3 (para 2-40) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (9) Position main light switch to OFF (TM 9-2320-365-10). Change 1 2-594.9 TM 9-2320-365-20-1