TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 939 of 1760
WARNING Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuits and cause severe burns or electrical shock. VOLTAGE TEST (1) Remove PDP cover (para 16-2). (2) Remove circuit breaker CB67 from PDP. (3) Set multimeter to volts DC. (4) Connect positive (+) probe of multimeter to circuit breaker CB67 socket 3 on PDP. (5) Connect negative (-) probe of multimeter to ground. (6) Position main light switch to SER DRIVE (TM 9-2320-365-10) and note reading on multimeter. (7) If 12 VDC is not present, go to step 2 of this fault. (8) If 12 VDC is present, repair wire 1912 from circuit breaker CB67 socket 3 to terminal board TB1 position 26 (para 2-40) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (9) Position main light switch to OFF (TM 9-2320-365-10). Change 1 2-584.53 TM 9-2320-365-20-1